Kangoo, mon Ndect à 20 :-(

[faradohm]

neither canclip or ddt will do this job....

here link to full folder with necessary files inside...

https://1drv.ms/f/s!AkVwgl0Wa_W6pXuGcNN ... Y?e=opoaqU

for proceed , expect on good section in the forum

interface needed in other folder rs232

[montergarage]

Thank you cery much I've already found rs232-obd interface and made it. Today I'll receive a laptop with windows 98 which I bought for this task

[faradohm]

So in good way...

[montergarage]

Is this interface rs232 for OBD is recognized somehow by windows98?

I powered it (12V and ground), then connect to rs232 port, but nothing happened

[Jerry]

Oubliez la connectivité, comme une connexion USB. Le port COM ne fait rien après connexion, la communication doit être activée par logiciel, en démarrant le programme.

[montergarage]

I need to make another copy od interface obd-rs232. There is no connection with bsl...

Tomorrow I will try to check com settings, but I think I made mistake somewhere when soldering

[faradohm]

Do you press adac Button AT bsl display ?
Then the board must shut down,
and only AT this Time run eewrite....

[montergarage]

Yes, I did it.
Instruction with files is quite precise.
Dashboard shut off after entering to bsl.

To reset I had to disconect 12V battery couple times.

Maybe someone has working interface for sale?

[montergarage]

It works!

I had speed in com settings set to 9600. I changed it to 19200 and IT works

Car is charging and drives forward and reverse. Now I'm going for longer test drive

[faradohm]

Eh super.
Need to adapt version , électrique or electroad.
And a perfect With onduleur calibration With motor,but nit nécessary if good forward speedy.

[montergarage]

I've made over 200km since virginization. Charging works at 10A and 16A without any problems.

I think car consumes more kWh/km and it's weeker.

Car is driving, but I think calibration is needed.

[faradohm]

What did i Say...